Difference between revisions of "CREATE PROCESS"
From Macros Wiki
| Line 5: | Line 5: | ||
:Then use [[SET_PROC_DATA]] again, once more for each process parameter. | :Then use [[SET_PROC_DATA]] again, once more for each process parameter. | ||
| − | |param1=<process type>|param1_desc=Process type, | + | |param1=<process type>|param1_desc=Process type, must be one of: |
| + | MILL_DRILL, MILL_CONTOUR, MILL_ROUGH, MILL_SURFACE, MILL_THREAD_MILL | ||
| + | LATHE_DRILL, LATHE_CONTOUR, LATHE_ROUGH, LATHE_THREAD | ||
| + | |||
|param2=<process number>|param2_desc=Process number. | |param2=<process number>|param2_desc=Process number. | ||
|param3=<tool number>|param3_desc=Tool number. | |param3=<tool number>|param3_desc=Tool number. | ||
Revision as of 18:19, 14 January 2011
Command
- CREATE_PROCESS <process type>, <process number>, <tool number>
- Create a process. Once created, use the SET_PROC_DATA command to set the process type.
- Then use SET_PROC_DATA again, once more for each process parameter.
Parameters
- <process type>
- Process type, must be one of:
MILL_DRILL, MILL_CONTOUR, MILL_ROUGH, MILL_SURFACE, MILL_THREAD_MILL LATHE_DRILL, LATHE_CONTOUR, LATHE_ROUGH, LATHE_THREAD
- <process number>
- Process number.
- <tool number>
- Tool number.
Process types.
MILL_DRILL, MILL_CONTOUR, MILL_ROUGH, MILL_SURFACE, MILL_THREAD_MILL
LATHE_DRILL, LATHE_CONTOUR, LATHE_ROUGH, LATHE_THREAD
Example
- CREATE_PROCESS MILL_CONTOUR, 3
- Note. An alternative method to create a process is to use the LOAD_PROCESS_FILE command to load a saved process file, then change the appropriate data using the [SET_PROC_DATA]] command.
