Difference between revisions of "CREATE PROCESS"
From Macros Wiki
| Line 20: | Line 20: | ||
|param2=<process number>|param2_desc=Process number. | |param2=<process number>|param2_desc=Process number. | ||
|param3=<tool number>|param3_desc=Tool number. | |param3=<tool number>|param3_desc=Tool number. | ||
| − | |||
| − | |||
| − | |||
| − | |||
}} | }} | ||
Revision as of 18:21, 14 January 2011
Command
- CREATE_PROCESS <process type>, <process number>, <tool number>
- Create a process. Once created, use the SET_PROC_DATA command to set the process type.
- Then use SET_PROC_DATA again, once more for each process parameter.
Parameters
- <process type>
- Process type, must be one of:
- MILL_DRILL
- MILL_CONTOUR
- MILL_ROUGH
- MILL_SURFACE
- MILL_THREAD_MILL
- LATHE_DRILL
- LATHE_CONTOUR
- LATHE_ROUGH
- LATHE_THREAD
- <process number>
- Process number.
- <tool number>
- Tool number.
Example
- CREATE_PROCESS MILL_CONTOUR, 3
- Note. An alternative method to create a process is to use the LOAD_PROCESS_FILE command to load a saved process file, then change the appropriate data using the [SET_PROC_DATA]] command.
