CREATE PROCESS

Up

Command

CREATE_PROCESS <process type>, <process number>, <tool number>

Create a process. Once created, use the SET_PROC_DATA command to set the process type.

Then use SET_PROC_DATA again, once more for each process parameter.

Parameters

<process type>

Process type, must be one of:

MILL_DRILL, MILL_CONTOUR, MILL_ROUGH, MILL_SURFACE, MILL_THREAD_MILL LATHE_DRILL, LATHE_CONTOUR, LATHE_ROUGH, LATHE_THREAD

<process number>

Process number.

<tool number>

Tool number.

Process types. MILL_DRILL, MILL_CONTOUR, MILL_ROUGH, MILL_SURFACE, MILL_THREAD_MILL LATHE_DRILL, LATHE_CONTOUR, LATHE_ROUGH, LATHE_THREAD

Example

CREATE_PROCESS MILL_CONTOUR, 3

Note. An alternative method to create a process is to use the LOAD_PROCESS_FILE command to load a saved process file, then change the appropriate data using the [SET_PROC_DATA]] command.