Commands Operation Data

From Macros Wiki
Jump to: navigation, search

Up

GET_OP_STATUS <op number> <status>
GET_OP_SELECTED <op number> <selected>
GET_OP_DATA <op number> <parameter> <value>
SET_OP_DATA <op number> <parameter> <value>
GET_OP_FEAT_ANGLES <op number> <feature number> <start angle> <end angle> <included angle>
GET_OP_FEAT_CTOOL <op number> <feature number> <ctool type> <x> <y> <z>
GET_OP_MARKER_DATA <op number> <marker number> <feature number> <param> <value>
COPY_OP_COMMENT_TO_PROC [<from op>] 14, 0, 37