HOLEFR GET HOLE Variables

From Macros Wiki
Jump to: navigation, search

Variables set by HOLEFR_GET_HOLE command

HOLEFR Variable Description Description
HoleFrSelected Number (0=not selected, 1=is selected) Is the hole selected
HoleFrType Number (from 1=simple to 9=compound) Hole type
HoleFrRefType Number (1=from solid, 2=from geometry) How was the hole created
HoleFrGeoRef Number If hole came from geometry, the geometry reference number
HoleFrGeoWG Number If hole came from geometry, the geometry workgroup number
HoleFrSolRef Number If hole came from a solid, the solid number
HoleFrWP Number Geometry or solid workpiece
HoleFrEndCond Number (1 to 5) End condition (blind/thru/thru blind/obstructed/spherical)
HoleFrUnits Number (0=metric, 1=inch) Hole units
HoleFrNumSegments Number Number of hole segments
HoleFrTopClear Number Top Clearance Amount
HoleFrBottomClear Number Bottom Clearance Amount
HoleFrTipAngle Number Tip Angle
     
HoleFrAxisX Number Hole axis vector measured from top to bottom
HoleFrAxisY Number  
HoleFrAxisZ Number  
     
HoleFrPosTopX Number Hole Position measured at the top of hole
HoleFrPosTopY Number  
HoleFrPosTopZ Number  
     
HoleFrPosBottomX Number Hole Position measured at the bottom of hole
HoleFrPosBottomY Number  
HoleFrPosBottomZ Number