IT Machine Data Parameter
From Macros Wiki
Variables set by HOLEFR_GET_DATA command
HOLEFR Variable | Description | Description |
HoleFrSelected | Number (0=not selected, 1=is selected) | Is the hole selected |
HoleFrType | Number (from 1=simple to 9=compound) | Hole type |
HoleFrRefType | Number (1=from solid, 2=from geometry) | How was the hole created |
HoleFrGeoRef | Number | If hole came from geometry, the geometry reference number |
HoleFrGeoWG | Number | If hole came from geometry, the geometry workgroup number |
HoleFrSolRef | Number | If hole came from a solid, the solid number |
HoleFrWP | Number | Geometry or solid workpiece |
HoleFrEndCond | Number (1 to 5) | End condition (blind/thru/thru blind/obstructed/spherical) |
HoleFrUnits | Number (0=metric, 1=inch) | Hole units |
HoleFrNumSegments | Number | Number of hole segments |
HoleFrTopClear | Number | Top Clearance Amount |
HoleFrBottomClear | Number | Bottom Clearance Amount |
HoleFrTipAngle | Number | Tip Angle |
HoleFrAxisX | Number | Hole axis vector measured from top to bottom |
HoleFrAxisY | Number | |
HoleFrAxisZ | Number | |
HoleFrPosTopX | Number | Hole Position measured at the top of hole |
HoleFrPosTopY | Number | |
HoleFrPosTopZ | Number | |
HoleFrPosBottomX | Number | Hole Position measured at the bottom of hole |
HoleFrPosBottomY | Number | |
HoleFrPosBottomZ | Number |