Difference between revisions of "LINE CA"

From Macros Wiki
Jump to: navigation, search
(New page: {{Command|syntax=LINE_CA <line number>, <circle>, <angle>, <option> |description=This is used to create a line that is tangent to a circle at a given degrees, the option ch...)
 
Line 1: Line 1:
{{Command|syntax=LINE_CA <[[line number]]>, <[[circle]]>, <[[angle]]>, <[[option]]>
+
{{Command|syntax=LINE_CA <line number>, <circle>, <angle>, <option>
 
|description=This is used to create a line that is tangent to a circle at a given degrees, the option changes which side the line is on the circle.
 
|description=This is used to create a line that is tangent to a circle at a given degrees, the option changes which side the line is on the circle.
  

Revision as of 16:03, 14 July 2010

Command

LINE_CA <line number>, <circle>, <angle>, <option>


This is used to create a line that is tangent to a circle at a given degrees, the option changes which side the line is on the circle.

Parameters

<line number>
The number of the line (1 to 100) to be defined. This is a number used by the macro to create other geometry.
<circle>
This refers to a previously defined point (1 to 100), this should be given in the format C(number).
<angle>
An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.
<option>
a value of 1 or 2 for choosing different options when creating objects

Example

- LINE_CA 4, 2, 63, 2