Difference between revisions of "POINT 2C"
From Macros Wiki
| Line 3: | Line 3: | ||
|param1=<point number>|param1_desc= The number of the point (1 to 100) to be defined. This is a number used by the macro to create other geometry. | |param1=<point number>|param1_desc= The number of the point (1 to 100) to be defined. This is a number used by the macro to create other geometry. | ||
| − | |param2=<circle>|param2_desc= This refers to a previously defined point (1 to 100), this should be given in the format | + | |param2=<circle>|param2_desc= This refers to a previously defined point (1 to 100), this should be given in the format C(number). |
|param3=<circle>|param3_desc= This refers to a previously defined point (1 to 100), this should be given in the format C(number). | |param3=<circle>|param3_desc= This refers to a previously defined point (1 to 100), this should be given in the format C(number). | ||
}} | }} | ||
===Example=== | ===Example=== | ||
| − | :- POINT_2C 11, | + | :- POINT_2C 11, C9, C2 |
[[Category:Geometry]] | [[Category:Geometry]] | ||
Revision as of 11:52, 13 July 2010
Command
- POINT_2C <point number>, <circle>, <circle>,
This is used to create a point between a 2 circles.
Parameters
- <point number>
- The number of the point (1 to 100) to be defined. This is a number used by the macro to create other geometry.
- <circle>
- This refers to a previously defined point (1 to 100), this should be given in the format C(number).
- <circle>
- This refers to a previously defined point (1 to 100), this should be given in the format C(number).
Example
- - POINT_2C 11, C9, C2
