Difference between revisions of "POINT CA"
From Macros Wiki
| Line 1: | Line 1: | ||
| − | {{Command|syntax=POINT_CA <point number>, <circle>, <angle>, | + | {{Command|syntax=[[Image:point_ca.png|right|POINT_CA]]POINT_CA <point number>, <circle>, <angle>, |
| − | |description= | + | |description=:Create a point on a circle at a certain angle from the center. |
|param1=<point number>|param1_desc= {{point number}} | |param1=<point number>|param1_desc= {{point number}} | ||
| Line 8: | Line 8: | ||
===Example=== | ===Example=== | ||
| − | : | + | :POINT_LC 1, 1, 33 |
[[Category:Geometry]] | [[Category:Geometry]] | ||
Revision as of 13:00, 21 July 2010
Command
- POINT_CA <point number>, <circle>, <angle>,
- Create a point on a circle at a certain angle from the center.
Parameters
- <point number>
- The number of a previously defined macro point.
- <circle>
- The number of an existing circle.
- <angle>
- angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.
Example
- POINT_LC 1, 1, 33
