Difference between revisions of "POINT CA"

From Macros Wiki
Jump to: navigation, search
Line 1: Line 1:
{{Command|syntax=POINT_CA <[[point number]]>, <[[circle]]>, <[[angle]]>,
+
{{Command|syntax=POINT_CA <point number>, <circle>, <angle>,
 
|description=This is used to create a point on a circle at a certain angle from the center.
 
|description=This is used to create a point on a circle at a certain angle from the center.
  

Revision as of 16:00, 14 July 2010

Command

POINT_CA <point number>, <circle>, <angle>,


This is used to create a point on a circle at a certain angle from the center.

Parameters

<point number>
The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
<circle>
This refers to a previously defined point (1 to 100), this should be given in the format C(Number).
<angle>
An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.

Example

- POINT_LC 15, 12, 4