Difference between revisions of "POINT CA"

Latest revision as of 11:05, 24 November 2014

POINT_CA <point number>, <circle>, <angle>

Create a point on a circle at a certain angle from the center.

<point number>: The number of the point to be created.; A number between 1 and 100.
<circle>: The number of an existing circle.
<angle>: Clockwise angle of rotation, use negative values for Counter-Clockwise.

POINT_CA 3, 1, 47

POINT_CA 4, 1, 156

@@ Line 1: / Line 1: @@
-{{Command|syntax=POINT_CA <[[point number]]>, <[[circle]]>, <[[angle]]>,
+[[Geometry:Creating_Geometry|{{Up}}]]
-|description=This is used to create a point on a circle at a certain angle from the center.
-|param1=<point number>|param1_desc=  The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
+{{Command|syntax=[[Image:point_ca.png|right|POINT_CA]]POINT_CA <point number>, <circle>, <angle>
-|param2=<circle>|param2_desc= This refers to a previously defined point (1 to 100), this should be given in the format C(Number).
+|description=:Create a [[macro_point|point]] on a circle at a certain angle from the center.
-|param3=<angle>|param3_desc= An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.<br/>Use the [[DEGREES]] or [[RADIANS]] commands to switch between the two angle modes.
+|param1=<point number>|param1_desc=  {{create point number}}
+|param2=<circle>|param2_desc= {{circle}}
+|param3=<angle>|param3_desc= {{CWangle}}
 }}
 ===Example===
-:- POINT_LC 15, 12, 4
+:POINT_CA 3, 1, 47
+:POINT_CA 4, 1, 156
 [[Category:Geometry]]