Difference between revisions of "POINT CA"

From Macros Wiki
Jump to: navigation, search
 
(9 intermediate revisions by one other user not shown)
Line 1: Line 1:
{{Command|syntax=POINT_CA <point number>, <circle>, <angle>,
+
[[Geometry:Creating_Geometry|{{Up}}]]
|description=This is used to create a point on a circle at a certain angle from the center.
 
  
|param1=<point number>|param1_desc=  The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
+
{{Command|syntax=[[Image:point_ca.png|right|POINT_CA]]POINT_CA <point number>, <circle>, <angle>
|param2=<circle>|param2_desc= This refers to a previously defined point (1 to 100), this should be given in the format C(Number).
+
|description=:Create a [[macro_point|point]] on a circle at a certain angle from the center.
|param3=<angle>|param3_desc= An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.<br/>Use the [[DEGREES]] or [[RADIANS]] commands to switch between the two angle modes.
+
 
 +
|param1=<point number>|param1_desc=  {{create point number}}
 +
|param2=<circle>|param2_desc= {{circle}}
 +
|param3=<angle>|param3_desc= {{CWangle}}
 
}}
 
}}
  
 
===Example===
 
===Example===
:- POINT_LC 15, 12, 4
+
:POINT_CA 3, 1, 47
 +
 
 +
:POINT_CA 4, 1, 156
  
  
  
 
[[Category:Geometry]]
 
[[Category:Geometry]]

Latest revision as of 11:05, 24 November 2014

Up

Command

POINT_CA
POINT_CA <point number>, <circle>, <angle>


Create a point on a circle at a certain angle from the center.

Parameters

<point number>
The number of the point to be created.
A number between 1 and 100.
<circle>
The number of an existing circle.
<angle>
Clockwise angle of rotation, use negative values for Counter-Clockwise.

Example

POINT_CA 3, 1, 47
POINT_CA 4, 1, 156