Difference between revisions of "POINT CA"

From Macros Wiki
Jump to: navigation, search
Line 2: Line 2:
 
|description=This is used to create a point on a circle at a certain angle from the center.
 
|description=This is used to create a point on a circle at a certain angle from the center.
  
|param1=<point number>|param1_desc=  The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
+
|param1=<point number>|param1_desc=  {{point number}}
|param2=<circle>|param2_desc= This refers to a previously defined point (1 to 100), this should be given in the format C(Number).
+
|param2=<circle>|param2_desc= {{circle}}
|param3=<angle>|param3_desc= An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.<br/>Use the [[DEGREES]] or [[RADIANS]] commands to switch between the two angle modes.
+
|param3=<angle>|param3_desc= {{angle}}
 
}}
 
}}
  

Revision as of 11:29, 16 July 2010

Command

POINT_CA <point number>, <circle>, <angle>,


This is used to create a point on a circle at a certain angle from the center.

Parameters

<point number>
The number of a previously defined macro point.
<circle>
The number of an existing circle.
<angle>
angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.

Use the DEGREES or RADIANS commands to switch between the two angle modes.

Example

- POINT_LC 15, 12, 4