From Macros Wiki
- POINT_CA <point number>, <circle>, <angle>,
This is used to create a point on a circle at a certain angle from the center.
- <point number>
- The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
- This refers to a previously defined point (1 to 100), this should be given in the format C(Number).
- An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.
- - POINT_LC 15, 12, 4