POINT CA

From Macros Wiki
Revision as of 11:29, 16 July 2010 by ConnerO (talk | contribs)
Jump to: navigation, search

Command

POINT_CA <point number>, <circle>, <angle>,


This is used to create a point on a circle at a certain angle from the center.

Parameters

<point number>
The number of a previously defined macro point.
<circle>
The number of an existing circle.
<angle>
angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.

Use the DEGREES or RADIANS commands to switch between the two angle modes.

Example

- POINT_LC 15, 12, 4