Difference between revisions of "POINT ROTATE"
From Macros Wiki
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Geometry:Creating_Geometry|{{Up}}]] | ||
| + | |||
{{Command|syntax=[[Image:point_rotate.png|right|POINT_ROTATE]]POINT_ROTATE <point number>, <xc>, <yc>, <angle> | {{Command|syntax=[[Image:point_rotate.png|right|POINT_ROTATE]]POINT_ROTATE <point number>, <xc>, <yc>, <angle> | ||
| − | |description=:Rotate a point about defined co-ordinates and a defined angle. | + | |description=:Rotate a [[macro_point|point]] about defined co-ordinates and a defined angle. |
|param1=<point number>|param1_desc= {{point number}} | |param1=<point number>|param1_desc= {{point number}} | ||
| Line 10: | Line 12: | ||
===Example=== | ===Example=== | ||
| − | :POINT_ROTATE | + | :POINT_ROTATE 1, 1, 1, 65 |
[[Category:Geometry]] | [[Category:Geometry]] | ||
Latest revision as of 18:02, 2 August 2010
Command
- POINT_ROTATE <point number>, <xc>, <yc>, <angle>
- Rotate a point about defined co-ordinates and a defined angle.
Parameters
- <point number>
- The number of a previously defined macro point.
- <xc>
- X co-ordinate of the center point.
- <yc>
- Y co-ordinate of the center point.
- <angle>
- angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.
Example
- POINT_ROTATE 1, 1, 1, 65
