Difference between revisions of "POINT ROTATE"

From Macros Wiki
Jump to: navigation, search
Line 1: Line 1:
{{Command|syntax=POINT_ROTATE <[[point number]]>, <[[xc]]>, <[[yc]]>, <[[angle]]>,
+
{{Command|syntax=POINT_ROTATE <point number>, <xc>, <yc>, <angle>,
 
|description=This is used to rotate a point about a circle.
 
|description=This is used to rotate a point about a circle.
  

Revision as of 17:01, 14 July 2010

Command

POINT_ROTATE <point number>, <xc>, <yc>, <angle>,


This is used to rotate a point about a circle.

Parameters

<point number>
The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
<xc>
The value of the center of the circle for the x axis.
<yc>
The value of the center of the circle for the y axis.
<angle>
An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.

Example

- POINT_ROTATE 15, 12, 4, 16