POINT ROTATE

From Macros Wiki
Revision as of 12:30, 16 July 2010 by ConnerO (talk | contribs)
Jump to: navigation, search

Command

POINT_ROTATE <point number>, <xc>, <yc>, <angle>,


This is used to rotate a point about a circle.

Parameters

<point number>
The number of a previously defined macro point.
<xc>
X co-ordinate of the center point.
<yc>
Y co-ordinate of the center point.
<angle>
angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.

Use the DEGREES or RADIANS commands to switch between the two angle modes.

Example

- POINT_ROTATE 15, 12, 4, 16