POINT ROTATE

From Macros Wiki
Revision as of 12:16, 13 July 2010 by ConnerO (talk | contribs) (New page: {{Command|syntax=POINT_ROTATE <point number>, <xc>, <yc>, <angle>, |description=This is used to rotate a point about a circle. |param1=<point number>|param1_desc= The num...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Command

POINT_ROTATE <point number>, <xc>, <yc>, <angle>,


This is used to rotate a point about a circle.

Parameters

<point number>
The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
<xc>
The value of the center of the circle for the x axis.
<yc>
The value of the center of the circle for the y axis.
<angle>
An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.

Example

- POINT_ROTATE 15, 12, 4, 16