Difference between revisions of "REVOLVE"
From Macros Wiki
(New page: {{Command|syntax=REVOLVE <axis>, <angle> |description=*DESCRPTION* |param1=<axis>|param1_desc={{axis}} |param2=<angle>|param2_desc={{}} }} ===Example=== :- REVOLVE Category:Solids) |
|||
| Line 3: | Line 3: | ||
|param1=<axis>|param1_desc={{axis}} | |param1=<axis>|param1_desc={{axis}} | ||
| − | |param2=<angle>|param2_desc={{}} | + | |param2=<angle>|param2_desc={{angle}} |
}} | }} | ||
Revision as of 10:38, 16 July 2010
Command
- REVOLVE <axis>, <angle>
- DESCRPTION*
Parameters
- <axis>
- The axis. Must be a single character, one of X, Y, H or V
- <angle>
- angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.
Example
- - REVOLVE
